Completion
Complete each
statement.
|
|
|
1.
|
Long hair must be
_________________ or worn under a cap when you operate the drill press.
|
|
|
2.
|
Be sure the bit is
________________, straight and in good condition.
|
|
|
3.
|
Set the drill ______________
for the type of cut that is going to be made.
|
|
|
4.
|
The _______________ in the
center of the table must be lined up directly under the cutting tool.
|
|
|
5.
|
Use ______________ to hold the
material firmly on the table.
|
|
|
6.
|
Use the _______________ to
tighten the chuck.
|
|
|
7.
|
Check ______________ to be sure
the chuck key has been removed from the chuck before you turn on the drill
press.
|
|
|
8.
|
Keep your hands and fingers
away from the area directly ________________ the drill bit.
|
|
|
9.
|
Back out of a deep cut from
time to time to prevent the bit from clogging and _____________.
|
|
|
10.
|
A piece of _____________ should
be used under the material when a hold is to be drilled all the way through the
stock.
|
|
|
11.
|
The drill press must be
__________________ stopped before changes or adjustments are made.
|
|
|
12.
|
Let the drill press coast to a
stop. ______________ try to stop it by hand.
|
|
|
13.
|
Use a ______________ to clear
waste material from the drill press table.
|
|
|
14.
|
Never leave the drill press
while it is still _____________. Wait fro it to come to a complete stop before you leave
it.
|
|
|
15.
|
Get the instructor’s
_______________ before you use any special set-ups or attachments.
|