Completion
Complete each
sentence or statement.
|
|
|
1.
|
Check the safety
guard over the _______________.
|
|
|
2.
|
Never _______________
the jointer while the cutterhead is turning.
|
|
|
3.
|
Check to see that all
locks are tightened _______________ before using the jointer.
|
|
|
4.
|
Never move hands
directly ______________ the cutterhead.
|
|
|
5.
|
Dull knives are more
likely to cause ______________.
|
|
|
6.
|
Keep hand(s) at least
________” away from the cutterhead.
|
|
|
7.
|
Feed stock through
the jointer so it will cut with the _______________ of the wood.
|
|
|
8.
|
Use a _______________
to determine if the fence is perpendicular to the table.
|
|
|
9.
|
Adjust the
_______________ table to achieve the desired cutting depth.
|
|
|
10.
|
Do not adjust
the _______________ table.
|
|
|
11.
|
Always use a
_______________ to joint stock less than 3” wide or less than ?” in
thickness.
|
|
|
12.
|
When edge jointing,
never make a cut deeper than _______ inch.
|
|
|
13.
|
When face jointing,
never make a cut deeper than ________ inch.
|
|
|
14.
|
The material must be
at least 12 inches long, _______ inch wide and ? inch thick.
|
|
|
15.
|
Use an
_______________when jointing long pieces of stock.
|
|
|
16.
|
Check the stock
carefully before jointing to be sure it is free of finishes, _______________, nails or other
objects.
|
|
|
17.
|
When jointing hold
stock tightly against the _______________.
|
|
|
18.
|
Don’t over-reach. Always plan the cut so you can stay
________________.
|
|
|
19.
|
Jointing across the end grain of the material should be _______________.
|
|
|
20.
|
Complete each pass on the jointer. Don’t interrupt the cut or try to
________________ of it.
|