Completion
Complete each
sentence or statement.
|
|
|
1.
|
The use of
_______________ floor strips is recommended for the floor area around the planer.
|
|
|
2.
|
Make certain all
_______________ are in place and securely fastened.
|
|
|
3.
|
The depth of cut
should never be set at more than ______ inch.
|
|
|
4.
|
_______________
lumber into the planer with the grain of the wood.
|
|
|
5.
|
Before
_______________ the planer, clear the machine and table area of chips, tools, or other
matter.
|
|
|
6.
|
Pass lumber
_______________ the planer, not over it.
|
|
|
7.
|
If the material gets
stuck in the planer, turn it off immediately and wait for it to come to a _______________
stop. Then you can lower the table to release the material.
|
|
|
8.
|
Make sure the board
to be planed is free of _______________ such as knots, paint, varnish, nails, dirt, and
grease.
|
|
|
9.
|
When feeding material
into the machine, stand to the side _______________ to the switch.
|
|
|
10.
|
Never _______________ material through the
planer.
|
|
|
11.
|
Never attempt to
surface lumber that is shorter than ______ inches.
|
|
|
12.
|
Do not
_______________ the planer by trying to cut more than the capacity of the
machine.
|
|
|
13.
|
_______________ the
electrical service in the circuit breaker before making any service adjustments to the planer or
before changing knives.
|
|
|
14.
|
Keep your fingers
away from the area between the stock and the surface of the _______________.
|
|
|
15.
|
_______________ wear
safety glasses.
|
|
|
16.
|
Use a helper or a
support stand to _______________ the lumber when planing.
|
|
|
17.
|
Do not operate the planer until you have learned to operate it correctly and
________________.
|
|
|
18.
|
___________________ look into the planer while it is operating.
|
|
|
19.
|
The planer should be set for the __________________ cut that will do the
job.
|
|
|
20.
|
Set the height of the planer _______________ turning the planer on.
|