Completion
Complete each
statement.
|
|
|
1.
|
Use the router only after you get _____________ from the
instructor.
|
|
|
2.
|
Don’t use the router
until its __________________ use has been demonstrated for you and you understand what you were
shown.
|
|
|
3.
|
__________________ must be worn
to help avoid eye injuries.
|
|
|
4.
|
__________________ must be worn
to protect your hearing.
|
|
|
5.
|
The router must always be
unplugged when it’s not in use and when you change __________________.
|
|
|
6.
|
Before you plug in the router,
check the __________________ to make sure it is in the OFF position.
|
|
|
7.
|
Be sure the bit is
__________________ and in good condition.
|
|
|
8.
|
A worn, dirty or damaged
collect can __________________ the router and the bit.
|
|
|
9.
|
The shank of the bit should be
inserted at least __________________ into the collect.
|
|
|
10.
|
Avoid touching the
__________________ of the bit.
|
|
|
11.
|
The chuck should be tightened
enough to hold the bit __________________, but not so tightly that the router is
damaged.
|
|
|
12.
|
Be sure the bit is clear of the
router __________________.
|
|
|
13.
|
The __________________ must be
secured after the router has been adjusted for the depth of the cut.
|
|
|
14.
|
Avoid making a cut that is too
deep. It is safer to make several __________________.
|
|
|
15.
|
The area of the stock that is
to be routed must be clean and free of any __________________.
|
|
|
16.
|
The stock must be surfaced and
smooth, and __________________ enough for the type of cut you plan to make.
|
|
|
17.
|
Material that is to be worked
on with the router should always be __________________.
|
|
|
18.
|
The __________________ of the
router must be kept clear of clamps or other objects.
|
|
|
19.
|
Plan the cut so you don’t
have to over-reach. Plan the cut so you can keep your __________________.
|
|
|
20.
|
Always hold the router firmly
with __________________ while you operate it.
|
|
|
21.
|
The bit must be
__________________ of the material when the router is switched on.
|
|
|
22.
|
Wait for the router to come up
to __________________ speed before you start the cut.
|
|
|
23.
|
Forcing the router or
__________________ it will damage the router and the material.
|
|
|
24.
|
The direction of feed should
always be __________________ the rotation of the bit.
|
|
|
25.
|
The bit should be clear of the
__________________ before the router is turned off.
|
|
|
26.
|
Wait for the router to come to
a __________________ stop before you set it down.
|
|
|
27.
|
The router should never be set
down on an __________________ bit.
|