Completion
Complete each
statement.
|
|
|
1.
|
Always properly ____________ the work to the
milling machine.
|
|
|
2.
|
Keep the machine table free of all tools and other
material. Do not remove chips from the table by ____________ or blow them off with compressed
air. Use a brush or vacuum cleaner for that purpose.
|
|
|
3.
|
Before inserting the arbor or adapters into the
____________, be sure both the arbor and spindle hole is clean and free from nicks.
|
|
|
4.
|
To avoid striking hands on the ____________ while
setting up, do the setup as far away from the cutter as possible.
|
|
|
5.
|
Do not attempt to clean or oil the machine or make
any ____________ to the work while the machine is in motion.
|
|
|
6.
|
When the operator has finished an operation, or
before leaving the machine for any reason, the ____________ should shut off the power and make sure
the machine has stopped.
|
|
|
7.
|
Always wear ____________ glasses and/or a face
shield when operating the milling machine.
|
|
|
8.
|
Do not wear ____________ clothing around the
milling machine.
|
|
|
9.
|
The ____________ is raised only by half
turns. The handle will be turned clockwise (to raise) or counterclockwise (to lower) and will
be at 12 or 6 o’clock.
|
|
|
10.
|
Enter the cutter into the workpiece ____________ to
avoid damage to the cutter or the workpiece.
|